If you are desired of embracing a wonderful driving experience, it will be a wise idea for you to install an all-in-one car radio which can support a lot of comprehensive features to meet your different needs in car. If you plan to remove the factory radio and install the new car radio by yourself, you can refer to a related installation guide. Today I would like to share a 2008 2009 2010 2011 2012-2015 Mazda 6 Rui wing car radio installation guide from Seicane with you. If you have the same or similar dashboard, please refer to this guide carefully.
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2008 2009 2010 2011 2012-2015 Mazda 6 Rui wing car radio installation guide
1. Remove the panel on downside of the e-brake. Please make sure your e-brake is up.
2. Remove the shift knob by screwing it off counterclockwise.
3. Remove the plastic part around the shift lever.
4. Release two side trims.
5. Remove the trim pieces around the air conditioning control. You may start from the bottom.
6. Remove four screws that fixed the AC control so as to drop down the AC control.
7. Unscrew two bottom screws that are holding the radio.
8. Grab the top panel so as to remove it.
9. Remove two last screws that are holding the radio with a screwdriver.
10. Gently take out the original radio.
11. Disconnect connectors and cables at the back of the radio. Please use a removal tool to help you.
12. Check all the accessories for the new Seicane car radio.
13. Connect the harnesses to the back of the new Seicane car radio.
14. Connect the Seicane car radio to your original stereo’s plugs.
15. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
16. Put the new Seicane car radio into the dash.
17. Put everything into their original place. All the installation is done.
Wish the above installation guide can be helpful for you to some degree. If you encounter any difficulties but don’t know how to overcome them, you can seek help from your dealer, someone experienced or a professional. However, before installation, please confirm that you have already got an ideal car radio that can work well with your car. If not, you might as well check out the following link which is an amazing 2008 2009 2010 2011 2012-2015 Mazda 6 Rui wing car radio from Seicane.
With this amazing car radio installed in your beloved car, it will reveal its super high performance and its great utility since it is upgraded to the advanced Android 6.0 operation system and a powerful quad-core CPU processor.
Thanks to the high-accuracy 3D GPS navigation system, you will have no trouble in knowing your current locations and finding the right way to reach your desired destinations through turn-by-turn directions and voice prompts. And with dual zone function, this unit allows you to freely enjoy beautiful music while navigating, which won’t have any negative influence on GPS function.
The smart Bluetooth module is especially built in this unit, so you can easily sync your Bluetooth-enabled mobile phone with this unit for Bluetooth hands-free calls and Bluetooth streaming music with keeping your hands on the steering wheel and your eyes on the road ahead.
If you like this unit, just add it to your shopping cart. Good luck!