With a step-by-step installation guide, some car owners can install a new car stereo in their car, while some may not. If you don’t have any experience on the installation, it maybe quite hard for you. In that case, you can turn to a professional for help. If you are a car owner of a 2003 2004 2005 2006 Jeep Wrangler, this 2003 2004 2005 2006 Jeep Wrangler car radio installation guide can be much helpful for you.
2003 2004 2005 2006 Jeep Wrangler car radio after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2003 2004 2005 2006 Jeep Wrangler car radio installation steps
1.Loosen the trim panel with a lever.
Loosen the trim panel with a lever
2.Take the panel off the dash and disconnect the wires from the car.
2-1.Take the panel off the dash and disconnect the wires from the car
2-2.Take the panel off the dash and disconnect the wires from the car
3.Remove the four screws which are holding the unit with a screwdriver.
Remove the four screws which are holding the unit with a screwdriver
4.Take out the unit and disconnect the wire harness at the back of the unit.
4-1.Take out the unit and disconnect the wire harness at the back of the unit
4-2.Take out the unit and disconnect the wire harness at the back of the unit
5.Check all the accessories for the new Seicane car radio.
Check all the accessories for the new Seicane car radio
6. Connect the harnesses to the back of the new Seicane car radio.
Connect the harnesses to the back of the new Seicane car radio
7. Connect the Seicane car radio to your original car radio ‘s plugs.
7-1. Connect the Seicane car stereo to your original car radio ‘s plugs
7-2. Connect the Seicane car stereo to your original car radio ‘s plugs
8.Put the new Seicane car radio into the dash.
9.Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
10.Put trim panel back on your new Seicane car radio after the normal test.
To make your upgrade successful, firstly, you need to pick up a right aftermarket radio for your car. If you are unsure which radio can fit your car, you can click the following link which is about an amazing 2003 2004 2005 2006 Jeep Wrangler car radio from Seicane and take it as a reference.
With this Jeep Wrangler car radio in your car, you are able to stay focused on the road ahead and keep your hands on the steering wheel to dial, receive, reject or mute the phone calls when you simply sync your compatible mobile phone with this unit via the Bluetooth connectivity. You can watch you favorite movies in your car to relax when you are outsides. To have a more relaxing trip on the way, this Jeep Wrangler car radio is just your great choice! Good luck to you!