
At present, it is a common phenomenon that more and more car owners tent to upgrade their factory radio for access to higher configuration and better performance. If you are one of them, you must want to have a general understanding of a car radio installation. In that case, you can refer to a correct instruction. This article will introduce how to install a 2005 2006 2007 2008-2012 Mercedes Benz ML CLASS W164 ML350 ML430 ML450 ML500 car radio. If you have the same or similar dashboard, you can take the following instruction as a reference.

2005 2006 2007 2008-2012 Mercedes Benz ML CLASS W164 ML350 ML430 ML450 ML500 GPS Bluetooth Car Radio after installation
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2005 2006 2007 2008-2012 Mercedes Benz ML CLASS W164 ML350 ML430 ML450 ML500 car radio installation instruction
1. The original car radio.
2. Pry the bottoming panel out of the dash with a plastic knife.
3. Pry the air conditioner panel out and remove it.
4. Remove two screws that fixed the radio on the dashboard with a screwdriver.
5. Use your finger to pull the buckles down.
6. Gently pull the factory radio out of the dash.
7. Then unplug the connectors at the back of the factory radio.
8. Check all the accessories for the new Seicane car radio.
9. Connect the harnesses to the back of the new Seicane car radio.
10. Connect the Seicane car radio to your originalradio’s plugs.
11. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
12. Put the new Seicane car radio into the dash.
13. Put everything into their original place. All the installation is done.
If you have any doubts, you should consult your dealer, communicate with someone experienced or seek help from a professional. For avoiding damage to either your car or your car radio, you can contact your dealer, communicate with someone experienced or seek help from a professional. Anyway, it is very vital for you to carefully select a suitable car radio for your beloved car. Here I would like to recommend a powerful 2005 2006 2007 2008-2012 Mercedes Benz ML CLASS W164 ML350 ML430 ML450 ML500 car radio from Seicane to you for your reference. For more details, please click:
This car radio’s operation system has been upgraded to the most advanced and super stable Android 8.0 operation system, and it has a powerful 8-core 1.5GHz Cortex-A53 CPU, 32GB Inland flash as well as 4GB RAM, which is modern enough to be regarded as the best replacement for your factory radio in your beloved car.
Under the help of the 3D GPS navigation system, you can easily know your current locations and accurately navigate to your destinations according to turn-by-turn directions and voice prompts.
Besides, the built-in wireless Bluetooth module of this car radio enables you to connect your Bluetooth-enabled mobile phone to this car radio, therefore, you can dial, answer, reject and mute Bluetooth hands-free calls and listen to Bluetooth streaming music from your phone music playlists with keeping your hands on the steering wheel and your eyes on the road ahead.
What are you waiting for? Just add this unit to your shopping cart right now!